Bosch TES 501 Série Mode D'emploi page 11

Masquer les pouces Voir aussi pour TES 501 Série:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 24
4. Assemble the milk frother. Only use the
appliance when the milk frother (6) is
completely assembled and fitted.
5� Lift the water tank lid (17).
6. Remove and rinse the water tank (16)
and fill it with fresh cold water. Do not fill
above the max mark�
7. Replace the water tank (16) and push it
firmly downwards into place.
8� Close the water tank lid (17).
9� Fill the bean container (1) with
c offee beans (for preparation using
ground coffee see "Preparation using
ground coffee").
10� Press the power on/off switch O / I (9) to
switch on the appliance. LED
F
and LED
lights up.
11� Place a container under the milk frother
outlet (6).
12� Carefully pull out the milk frother (6)
to open it. The appliance rinses out
the milk frother (6) with water. LED
flashes.
F
13� When LED
lights up constantly,
press in the milk frother (6) to close it.
The appliance heats up and rinses. Some
water will run out of the coffee outlet. When
A
B
buttons
(12),
up, the appliance is ready for use.
D
flashes
C
(11) and
(10) light
Switching off the appliance
The factory settings of the fully automatic
espresso machine are programmed for
optimal performance. The appliance
switches off automatically after a specific
time (the length of time can be adjusted,
see " S ettings" – "Automatic switch-off").
Exception: The appliance switches off
without rinsing if only hot water or steam
was dispensed�
To switch the appliance off manually before
this, press the service button (12).
The appliance rinses and switches off.
Note: If the appliance is being used for the
first time, the service programme has been
run, or the appliance has not been operated
for a long period, the first beverage will
not have the full aroma and should not be
consumed.
When the fully automatic espresso machine
is first used, you will achieve a suitably thick
and stable "crema" only after the first few
cups have been dispensed.
If the appliance is in use for a long period
of time, water droplets will form on the
v enti l ation slits. This is normal.
F
en
7

Publicité

Table des Matières
loading

Table des Matières