Scu - Mennekes AMTRON Xtra Manuel D'utilisation

5.1.5 "SCU"

Operating mode "SCU"
Start of charging With RFID card:
process „ Authentication with valid RFID card
Via the ACU (Remote).
Controlling the By using the higher-level back-end system:
charging pro- „ Control takes place completely over the higher-level back-end system.
cess
By using the multifunction button:
„ Terminating the charging process
The stop function with the multifunction button must be enabled during the setting-up process.
With RFID card:
„ Terminating the charging process with the same card used for starting the charging process.
Setting up the To use the operating mode "SCU" it is necessary to integrate further devices and an ACU in the net-
operating mode work and to install a higher-level back-end system.
f If necessary, it has to be installed by a qualified electrician.
Changing the Via the service interface of a qualified electrician:
operating mode „ Changing to all operating modes configured during the setting-up process.
The change of operating mode will apply for the on-going and subsequent charging processes.
Behaviour after The behaviour after a power failure is configured during setting-up process.
a power failure „ The charging process is aborted (default with and without RFID card reader).
„ The charging process is continued.
18
In operating mode "SCU", all functions of other operating modes are disabled. Using the
MENNEKES Charge APP is not possible.