Bosch MUM59 Série Mode D'emploi page 24

en Bowl and tools
Working with the continuous-
feed shredder
Figure H:
■ Press the Release button and
move the swivel arm to
position 2.
■ Insert the bowl:
Tilt the bowl forwards and then set it
down. Turn anti-clockwise until it locks
into place.
■ Press the Release button and
move the swivel arm to
position 3.
■ Remove drive cover from the drive of the
continuous-feed shredder (Fig. H-5a).
■ Hold disc holder at the lower end, ensur-
ing that the two tips are face up.
■ Carefully place the required slicing or
shredding disc onto the tips of the disc
holder (Fig. H-6a). In the case of reversi-
ble discs, ensure that the required side is
face up.
■ Grip disc holder at the upper end and
insert into the housing (Fig. H-6b).
■ Attach the cover (note mark) and turn all
the way in a clockwise direction.
■ Place continuous-feed shredder on the
drive and rotate all the way in a clockwise
direction, as illustrated in Fig. H-8.
■ Turn rotary switch to recommended
setting.
■ Put food to be processed in the feed tube
and push down with the pusher.
W Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in
the continuous-feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove
cover from the continuous-feed shredder
and empty feed tube.
24
125_MUM59xxx_8001027205.indb 24
After using the appliance
■ Switch off the appliance with the rotary
switch.
■ Rotate the continuous-feed shredder in
an anti-clockwise direction and remove.
■ Rotate the lid in an anti-clockwise direc-
tion and remove.
■ Remove disc holder with disc. To do this,
press finger from below against the drive
shaft (Fig. J).
■ Clean parts.
Blender
W Risk of injury from sharp blades /
rotating drive!
Never place fingers in the attached blender!
Do not remove / attach the blender until the
drive is at a standstill! Operate the assem-
bled blender only and with the lid attached.
W Risk of scalding!
If processing hot liquids, steam escapes
through the funnel in the lid. Add a max. 0.5
litres of hot or frothing liquid.
Warning!
Blender may be damaged. Do not process
deep-frozen ingredients (except ice cubes).
Do not operate blender when empty.
Working with the blender
Figure K:
■ Press the release button and
move the swivel arm to
position 4.
■ Remove the blender drive cover.
■ Attach blender jug (mark on the handle
on mark on the base unit) and turn all the
way in an anti-clockwise direction.
■ Add ingredients.
Maximum capacity – liquid = 1.25 litres;
maximum capacity frothing or hot liquids
max. 0.5 litres; optimal processing
c apacity – solids = 50-100 g;
■ Attach the cover and turn anti-clockwise
all the way into the blender handle. The
cover must be locked in position.
■ Set the rotary switch to the desired
setting.
30.11.2015 16:07:06