Safety Instructions - DoorBird A1081 Série Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Safety instructions

N OT IC E
• The device shall be used in compliance with local laws and regulations.
• Store the device in a dry and ventilated environment.
• Avoid exposing the device to shocks or heavy pressure.
• Do not install the device on unstable brackets, surfaces or walls. Make
sure the material is strong enough to support the weight of the device.
• Use only applicable tools when installing the device. Using excessive
force with tools could cause damage to the device.
• Do not use chemicals, caustic agents, or aerosol cleaners.
• Use a clean dry cloth for cleaning.
• Use only accessories that comply with technical specification of the
device. These can be provided by Bird Home Automation GmbH.
• Use only spare parts provided by or recommended by Bird Home
Automation GmbH.
• Do not attempt to repair the device by yourself. Contact Bird Home
Automation GmbH for service matters.
• Keep the device more than 1 m (3.3') away from microwave, radio, TV,
wireless router and any other wireless devices.
• On devices with intercom or built-in speaker or built-in microphone or
signal transmission functions, keep the wires more than 30 cm (12'')
away from AC 100-240 V wiring. AC induced noise and/or device
malfunction could result.
• Install the device in an area that will be accessible for future inspections,
repairs and maintenance.
• If the device is used close to a cellular phone, the device may malfunction.
• The device can be damaged if dropped. Handle with care.
• The device turns inoperative during power failure.
• On devices with intercom or built-in speaker or built-in microphone,
in areas where cellular or Radio / TV broadcasting station antennas are
closeby, the device may be affected by radio frequency interference.
• On devices with LCD screen, it must be noted in advance that the LCD
panel, though manufactured with very high precision techniques,
inevitably will have a very small portion of its picture elements always lit
or not lit at all. This is not considered a device malfunction.
• On devices with intercom, due to the environmental sound around
the device, it may hinder smooth communication, but this is not a
malfunction.
6 6

Publicité

Table des Matières
loading

Table des Matières