DoorBird A1081 Série Manuel D'installation page 10

INSTALLATION
All the steps below should be carried out carefully by a competent adult,
taking into consideration any applicable safety regulations. Should you have
any questions, please contact us or a competent specialist directly.
Please ensure that all wires used for the installation are undamaged along
their entire length and approved for this type of use.
Network speed and network components
Please ensure that the upload speed of your Internet connection is at least
0.5 Mbps. You can also carry out a speed test at any time via the DoorBird App.
The user experience is only as good as your network speed, network stability
and quality of your network components, such as your Internet Router and
WiFi access points or WiFi repeaters. Please also make sure that your network
components are no older than two years old, have been manufactured by a
well-known manufacturer, and have the latest firmware installed.
Should these requirements not be fulfilled, it may occur, for example that the
performance of audio and video is poor or push notifications are delayed or
do not arrive on your smartphone or tablet at all.
Requirements:
High-speed Internet (via landline): DSL, cable or optical fibre
Network: 802.11b/g/n 2.4 GHz or Ethernet, with DHCP
1
SWITCHING OFF POWER
Switch off the power to all wires leading to the assembly location,
i.e. the door chime, electric door opener, power supply unit for the
video door station etc..
2
DETERMINING THE ASSEMBLY LOCATION
The device is IP50 certified (not water-proof). Please make sure to
put the device into an appropriate housing if you want to use it
outdoors.
The network cable between the device and the PoE-Switch/PoE-Injector/
Internet Router can have a maximum length of 80 meters/262 feet.
You can mount the device permanently on a wall or ceiling. If you do not
want to mount it permanently, please skip the rest of this step.
10