Connecting The Device - DoorBird A1081 Série Manuel D'installation

Do not plug the power supply unit into the wall socket yet. Only use
NOTIC E
the power supply unit provided along with the device, or a DIN-rail
power supply unit that you can obtain from us separately, since this
has been specially stabilized electrically and is equipped with an
integrated audio interference reduction device. Other power
supply units may destroy the device or cause poor transmission
quality. The warranty expires automatically if you use a different
power supply unit.
OPTION 2
Power supply via PoE
To power the device via a PoE-Switch (e.g. D-Link DGS-1008P) or PoE-Injector
(e.g. DoorBird Gigabit PoE Injector) in accordance with the PoE standard
IEEE 802.3af Mode A, the four wires bearing the numbers 1, 2, 3 and 6 of a
Cat.5 cable or better are to be used. A Cat.5 cable or better must be used
as network signals can only be transmitted over completely insulated,
shielded and twisted cables. If you use PoE as a source of power, the WiFi
interface of the device is automatically inactive, and the four wires for PoE
then simultaneously form the data link. The device won't start if your PoE-
Switch/PoE-Injector does not support the PoE Standard IEEE 802.3af Mode
A (see Diagnostic-LED and Diagnostic-Sounds).
1. Disconnect the PoE-Switch or PoE-Injector from the power grid.
2. Run the network cable to the installation location of the device.
You can find further information about PoE here: http://www.doorbird.com/poe
5

CONNECTING THE DEVICE

It is possible to connect the cables and wires to the device conveniently and
safely via labelled connection ports. You can connect all necessary cables
and wires to the device now. Please remove any cables and wires from the
connection ports of the device that you do not need.
Remove about 5 mm of insulation material at the end of the wires that you
would like to connect to the green screw connection terminal of the device.
12