What If There Are Problems - Inanny NM288 Manuel D'utilisation

• You will get the maximum capacity from your battery if you run down the
battery at least once every six months. To do this, disconnect the parent unit
from the mains and run the battery down through normal use. Then fully
charge the battery up again.
• The maximum battery capacity can only be reached after it has been
charged several times and is dependent on many factors (battery state,
ambient temperature, means and frequency of charging, etc.).
• Protect the camera and the parent unit from knocks, damp, dust, chemicals,
drastic changes in temperature, electromagnetic fields and nearby sources of
heat (ovens, heaters).
• Clean the camera/parent unit with a soft, dry cloth. Do not use any abrasive
cleaning products.

13. What if there are problems?

IMPORTANT Forgotten password
If you have forgotten your password, tap " Forgotten password " in the app and
enter your e-mail address. A new password will be sent to your e-mail address.
Problem
The parent unit will not switch on.
An acoustic signal sounds from the
parent
unit.
The parent unit is switched on, but is not
making any noise.
The parent unit switches itself off.
The signal is weak, the connection
keeps breaking up or there is
interference.
Solution
Check whether
• the "Monitor" mains part plug is properly plugged in,
• the battery is correctly inserted,
• the battery is full, needs charging or is damaged.
Check whether
• the maximum range has been exceeded,
• the mains part plug for the camera ("Baby") is correctly
connected,
• the camera is switched on,
To set your desired volume on the parent unit, press the right or left
direction arrows during operation.
• Recharge the parent unit's battery.
• It could be that the parent unit is in energy-saving mode. Check
whether the power-saving mode has been selected in the menu
and deactivate it where necessary.
• If another technical device such as a microwave is in the area
between the camera and the parent unit, remove the technical
device or switch it off.
• Check whether other factors, such as trees or anything else, are in
the area between the camera and the parent unit, and change
the position of the devices until the parent unit signals a
connection.
•
Check whether the camera and parent unit are inside the
maximum receiving range.
16