What If There Are Problems - Inanny NM204 Manuel D'utilisation

10. What if there are problems?

"Monitor" parent unit will not Check whether
"Monitor" parent unit will
not switch on.
An acoustic signal sounds
An acoustic signal
from the "monitor" parent
sounds from the
unit.
"monitor" parent unit.
The parent unit is switched on,
The parent unit is
but is not making any noise.
switched on, but is not
making any noise.
The "monitor" parent
unit switches itself off.
The "monitor" parent unit
switches itself off.
The signal is weak, the
If no transmission is possible,
you have the option to
The signal is weak, the
retune
connection keeps
the device signals digitally =
breaking up or there is
pairing.
interference.
If no transmission is
possible, you have the
option to retune the
device signals digitally =
pairing.
Check whether
•
the mains part plug is correctly connected,
• the mains part plug is correctly connected,
•
the battery is correctly inserted,
• the battery is correctly inserted,
• the battery is full, needs charging or is damaged.
•
the battery is full, needs charging or is dama
Check whether
Check whether
•
the maximum range has been exceeded,
• the maximum range has been exceeded,
•
• the mains part plug for the camera is correctly
the main part plug for the camera is
connected,
correctly connected,
• the camera is switched on,
•
the camera is switched on,
• the parent unit's battery needs charging.
•
the parent unit's battery needs charging.
•
• To set your desired volume on the parent unit, To set your desired volume on the parepress
the right or left arrow buttos during operation.
press the right or left arrow buttons during
operation.
•
Recharge the parent unit's battery,
•
It could be that the parent unit is
energy-saving
• Recharge the parent unit's battery,
mode. Check whether the power-savi modh
• It could be that the parent unit is in
been selected in the menu and deactiv
energy-saving mode. Check whether the
ere necessary.
power-saving mode has been selected in the
menu and deactivate it where necessary.
1. Switch on the camera and parent unit.
• If another technical device such as a microwave
2. Delete the camera in the menu of the parent
is in the area between the camera and the parent
unit
unit, remove the technical device or switch it off.
and the set up the camera again
• Check whether other factors, such as trees or
described in the "Add camera" section.
anything else are in the area between the camera
and the parent unit, and change the position of
the devices until the parent unit signals a
connection.
• Check whether the camera and parent unit are
inside the maximum receiving range.
1. Switch on the camera and parent unit.
2. Delete the camera in the menu of the parent
unit and the set up the camera again as described
in the "Add camera" section.
11