•
When adjusting the flap by hand, stop the unit.
•
When humidity is high, condensation can occur. Adjusted to left or at the air outlet if
all vertical louvers are right.
•
Avoid keeping the horizontal flap on a downward position for a long time in COOL or
DRY mode, otherwise, condensation can occur.
When the unit starts again after a remote power off, the remote controller automatically memorizes
the previous set swing position.
4.2. SLEEP mode
Press SLEEP button
Press again the SLEEP button
▪
Operation mode
In COOL, DRY mode
1 hours after SLEEP mode starts, temperature rises 1°C higher than temperature setting. After another
1 hour, temperature rises by 1°C again. The unit runs for 6 more hours then stops. Temperature is
higher than temperature setting so that room temperature is not too low for your sleep.
In HEAT mode
1 hour after SLEEP mode starts, temperature decreases 2°C lower than temperature setting. After
another 1 hour, temperature decreases by 2°C again. After more another 3 hours, temperature rises
by 1°C again. The unit runs for 3 more hours then stops. Temperature is lower than temperature
setting so that room temperature is not too high for your sleep.
40
. The remote controller displays
to cancel the function.
SLEEP operation starts
1 hr
Rises 1°C
1 hr
Temperature setting
In COOL, DRY mode
Temp. setting
1 hr
Decreases 2°C
1 hr
SLEEP
operation starts
In HEAT mode
. The SLEEP function is ON.
SLEEP operation stops
Approx.6hrs
Rises 1°C
Unit stops
Unit stops
Decreases 2°C
3 hrs
3 hrs
Rises 1°C
SLEEP
operation stops