Ryobi RTS22 Manuel D'utilisation page 15

 Place the saw on a flat surface with the underside of the
saw facing up.
 Cut the zip tie that holds the support brackets together.
 Fold out the stand. Use the latch to secure the free end
of the support bracket to the frame of the saw. (See
Figure 6.)
INSTALLING STAND LEGS
 Assemble each side separately. Install all legs with feet
pointing outward.
 Carefully remove the bolt from the support bracket while
holding the pivot plate in place. Set the bolt aside.
 Locate one of the legs with two holes drilled into it. Insert
the leg into the inner stand support bracket tube.
NOTE: The two holes are for installing the crosspiece.
 Align the hardware holes of the inner and outer support
brackets and pivot plate. Insert the bolt through all pieces
and secure with a lock nut. Tighten the nut using a
13 mm wrench. Then loosen nut slightly to allow legs to
pivot freely.
NOTE: Do NOT overtighten as this will not allow the stand
to move freely.
 To repeat on the other side, remove the bolt. Insert the
leg with two holes into the inner stand support bracket.
Insert the with the adjustment foot into the outer support
bracket.
INSTALLING THE CROSSPIECE
 Place the crosspiece in position as shown, aligning the
holes in the crosspiece with the holes in the lower part
of the stand.
 Slide each of the four 5 mm hex bolts through the holes
in the crosspiece and the holes in the legs.
 Place a lock nut over each bolt. Securely tighten the nut
using an 8 mm wrench and socket.
LATCH
ASSEMBLY
LEG
PIVOT
PLATE
INNER STAND
SUPPORT
BRACKET
INNER
STAND
SUPPORT
BRACKET
Fig. 6
15 - English
HOLES
NUT
PIVOT
PLATE
OUTER STAND
SUPPORT
BRACKET
BOLT(S)
BOLT(S)
LEG
BOLT
Fig. 7
CROSSPIECE
NUT(S)
OUTER
STAND
SUPPORT
BRACKET
Fig. 8