Scheppach TS82 Traduction De La Notice Originale page 30

Such damaged electrical connection cables must not
be used and are life-threatening due to the insulation
damage.
Check the electrical connection cables for damage regu-
larly. Make sure that the connection cable does not hang
on the power network during the inspection.
Electrical connection cables must comply with the ap-
plicable VDE and DIN provisions. Only use connection
cables with the marking „H05VV-F".
The printing of the type designation on the connection
cable is mandatory.
Troubleshooting
Problem Possible Cause
1. Saw blade gets Fastening nut tightened insufficiently
loose after turning
off the motor
2. Motor does not start a) Failure mains fuse
b) Extension cable defect
c) Connections to the engine or
switch out of order
d) Connections on the motor or switch
defect
3. Motor reverse a) Capacitor defective
rotation
b) Incorrect connection
4. Motor does not a) Cross section of the extension
perform, the fuse cable insufficiently
responds
b) Overload by dull saw blade
5. Burns on the cutting a) dull saw blade
surface
b) Wrong saw blade
30 І 48
 www.scheppach.com  service@scheppach.com  +(49)-08223-4002-99  +(49)-08223-4002-58
AC motor
• The mains voltage must be 230 V~
• Extension cables up to 25 m long must have a cross-section
of 1.5 mm .
2
Connections and repairs of electrical equipment may only be
carried out by an electrician.
Please provide the following information in the event of any
enquiries:
• Type of current for the motor
• Machine data - type plate
• Motor data - type plate
Help
Tighten fastening nut
a) Check the mains fuse.
b) Change extension cable
c) Have it checked by an electrician
d) Have it checked by an electrician
a) Have it checked by an electrician
b) Then switched by a qualified electrician polarity of the
wall socket
a) see electrical connection
b) Change saw blade
a) Change saw blade
b) Change saw blade