Lubrication; Front Handle Replacement; Blade Replacement - Toro 51815 Manuel De L'utilisateur

1. DISCONNECT TRIMMER FROM POWER
SUPPLY.
2. Apply light machine oil along the edge of the
top strap as shown in Figure 9.
Your trimmer should be stopped, disconnected, and
oiled occasionally during use.

Lubrication

All of the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life
of the unit under normal operating conditions.
Therefore, no further lubrication is required.

Front Handle Replacement

(Fig. 10)
If the front handle on your hedge trimmer becomes
broken or damaged, replace immediately.
NEVER USE HEDGE TRIMMER WITH A
BROKEN, DAMAGED OR LOOSE FRONT
HANDLE.
1. DISCONNECT TRIMMER FROM POWER
SUPPLY.
2. Using a flat blade screwdriver, remove screw
securing handle.
3. Spread ears of handle and remove broken or
damaged handle from your trimmer.
4. Fit the ears of the replacement front handle into
the handle slots in motor housing.
5. Rotate handle back and forth until recessed key
slot in handle engages and locks in position with
raised key slot in motor housing.
6. Insert screw through the handle and motor
housing.
7. Start screw threads into the hex nut using a flat
blade screwdriver and tighten securely.
POTENTIAL HAZARD
If front handle is not installed, fingers
could contact moving blade.
WHAT CAN HAPPEN
Contact with moving blade could cause
serious personal injury.
HOW TO AVOID THE HAZARD
Check to be sure handle is secure before
each use.
If handle screw vibrates loose, tighten it
securely with a flat blade screwdriver.
Do not use trimmer without front handle
installed securely in place.

Blade Replacement

1. DISCONNECT HEDGE TRIMMER FROM
POWER SUPPLY.
2. Place hedge trimmer upside down on workbench
and remove blade cover screws (Fig. 11).
3. Remove blade cover: To remove, lift at the rear
of blade cover.
4. Rotate cam assembly clockwise so that blade
assembly slot is aligned with cam assembly
(Fig. 12).
Note: A Phillips screwdriver, 1/4 in. socket,
or 1/4 in. nut driver is required to
rotate cam assembly.
5. Remove blade screws (Fig. 13).
6. Remove blade assembly. To remove, lift and
rotate blade assembly from cam assembly.
7. Check alignment of new blade assembly
(Fig. 14).
EN–10