General - Toro 51815 Manuel De L'utilisateur

Note: If alignment is needed, manually slide
blade assembly back and forth until
slots in blade assembly are aligned and
will fit over cam assembly.
POTENTIAL HAZARD
Blades are sharp.
WHAT CAN HAPPEN
Contact with sharp blades can cause
serious personal injury.
HOW TO AVOID THE HAZARD
Make sure unit is unplugged. Wear gloves
while making adjustment. When manually
sliding blade assembly, do not place your
hand or fingers between blades or in any
position where they could get pinched or
cut.
8. Position new blade assembly over cam assembly,
then continue to manually slide blade assembly
until screw holes in blade assembly align with
screw holes in motor housing (Fig. 14).
Note: When properly aligned, blade
assembly fits in recessed slot in motor
housing.
9. Replace blade screws. Tighten screws securely.
10. Replace blade cover. Reposition tabs on front of
blade cover under front blade guard and lower
rear of blade cover into place (Fig. 15 & 16).
11. Replace blade cover screws.
12. Tighten screws securely.
EN-11
POTENTIAL HAZARD
If blade cover is not securely fastened in
place, internal parts will be exposed.
WHAT CAN HAPPEN
Contact with exposed internal parts could
cause serious personal injury or death.
HOW TO AVOID THE HAZARD
Make sure blade cover is replaced before
connecting your hedge trimmer to power
supply.

General

Avoid using solvents when cleaning plastic parts.
Most plastics are susceptible to various types of
commercial solvents and may be damaged by their
use. Use clean cloths to remove dirt, carbon dust, etc.
POTENTIAL HAZARD
Plastic parts can be damaged, weakened or
destroyed by many cleaning solvents and
other fluids.
WHAT CAN HAPPEN
Damaged parts can cause trimmer to
operate improperly which could lead to
serious personal injury.
HOW TO AVOID THE HAZARD
Do not at any time let brake fluids,
gasoline, petroleum-based products,
penetrating oils, etc., come in contact with
plastic parts. They contain chemicals that
can damage, weaken or destroy plastics.