Weighing; Segment Test - HBM SLS Guide Rapide

Weighing

4 Weighing
4.1

Segment test

The scale is ready to use about 10 seconds after it has been switched on.
Important
Do not move the scale or load it during this time!
1 x
1)
If the initial (tare) loading of the scale exceeds 20% of the weighing range, automatic zeroing
does not take place. In this case, taring must be done manually (see section 4.4).
8
HBM Short Reference Guide Lifter Scale A1221-6.0 Issue Oct. 1, 2016
"
Press the ON/OFF key once to switch the scale on
Display segment test (X5 seconds)
Please watch during the automatic segment test to make sure
that as shown, all the segments are on for approx. 5 seconds
and off for approx. 2 seconds. If you notice that a segment is
faulty, the scale must be repaired.
Then all the segments go out (X2 seconds)
Display of software used
Automatic zeroing
1)
(X3 seconds)
SLS