Technical Data; Attachment And Operation - Scheppach 5903405901 Traduction Des Instructions D'origine

• Never leave the working area of the sanding ma­
chine while the tool is running, or as long as it has
not come to an absolute standstill.
• Always place the work piece on the grinding table.
To sharpen bent tools with the grinding disc, place
them securely on the table.
Remaining hazards
The machine has been built using modern technology
and in accordance with recognized safety rules.
Some hazards, however, may still remain.
• The grinding wheel poses a danger of injury to fin­
gers and hands by improper feeding or placement
of tools.
• Danger of injury from thrown tools due to improper
holding or feeding.
• The use of incorrect or damaged mains cables can
lead to electrical injuries.
• Although having regarded all considerable rules
there may still remain not obvious remaining hazrds.
• Minimize remaining hazards by following the in­
structions in "Safety Rules", "Use only as author­
ized" and in the entire operating manual.

6. Technical data

Dimensions L x W x H (mm)
Speed (1/min)
Oscillation stroke (mm)
Belt dimensions (mm)
Belt Speed (m/s)
grinding height max. (mm)
Table Size (mm)
Table Tilt
Vacuum connector ø (mm)
Weight (kg)
Drive
Motor (V~/Hz)
Power (W)
Subject to technical changes!
Total vibration values determined in accordance with
EN61029
sound pressure level L
pA
uncertainty K
pA
sound power level L
WA
uncertainty K
WA
Wear hearing protection.
The effects of noise can cause a loss of hearing. Total
vibration values (vector sum - three directions) deter­
mined in accordance with EN 61029.
 www.scheppach.com /  service@scheppach.com /  +(49)-08223-4002-99 /  +(49)-08223-4002-58

7. Attachment and operation

Before starting the equipment
Before you connect the equipment to the mains
supply make sure that the data on the rating plate
are identical to the mains data.
m WARNING!
Always pull the power plug before making
adjustments to the equipment.
• All covers and safety devices have to be properly
• It must be possible for the grinding/sanding belt
• When working with wood that has been processed
• Before you actuate the On/Off switch, make sure
Connection to vacuum suction.
The use of an extraction system is recommended.
7.1. Tool changes, Fig. 2 - 7
m ATTENTION! Turn off the machine and disconnect
the main plug.
465/420/500
When changing tools make sure to have all parts
2000
cleaned.
16
• Prepare the appropriate tool and mount it as fol­
610x100
8
• Insert cover (6) in table (2)
• Insert stage plate (8) into the cover (6) (Fig. 4)
90
• Attach the lower spindle disc (7) to the spindle (1)
410x425
0°­45°
• Slide the abrasive sleeve (9) onto the rubber sleeve
38
12,9
• Apply the disc (D) (use the correct measurements)
• Put on the hex­nut and tighten it with the hook
220-240/50
450
Be sure always to mount the correct parts when
changing the abrasive sleeves. The table inlays have
to be bigger than the abrasive sleeves.
Note! The 13 mm abrasive sleeve is put directly onto
the spindle (1).
76 dB(A)
3 dB
89 dB(A)
3 dB
fitted before the equipment is switched on.
and disk to run freely.
before, watch out for foreign bodies such as nails
or screws, etc.
that the abrasive paper is correctly fitted and that
the equipment's moving parts run smoothly.
lows:
(fig.5).
(7) (fig. 5).
(fig. 7).
wrench (F). (fig. 8)
GB | 21