During Operation - Dräger Pac 6 00 Série Notice D'utilisation

en Use
If the gas monitor is turned off, the values for the peak concentration, TWA
and STEL are deleted.
4.3

During operation

WARNING
Danger to life and/or risk of explosion!
The following alarms may indicate a danger to life:
 A2 alarm
 STEL or TWA alarm
 Device error
► Immediately leave the hazard area.
The continuous operation of the gas monitor is indicated by an optical and/or
acoustic operation signal that is emitted in a 60-second cycle (configurable using
the Dräger CC-Vision PC software).
The acoustic operation signal must be switched on for measurements in
accordance with EN 45544 (CO, H
If the allowable measuring range is exceeded or a negative zero drift occurs, the
following message appears in the display:
(negative drift).
The measuring channels do not need to be checked after a short-term over
range (up to one hour) by the EC measuring channels (this does not apply if
using DrägerSensor XXS CO H
In the event of an alarm, the corresponding displays, the visual, audible and
additionally the vibration alarm, are activated, see section 6.2 on page 25.
 Push the [▼] button to light up the display.
22
S) or in accordance with EN 50104 (O
2
(concentration too high) or
-CP).
2
).
2