Aerial Connection; Speaker Connection - Sharp CD-CH1500W Mode D'emploi

! Removing the transport screw
Before turning the power on, be sure to remove the transport screw on the
back of the unit using a flat-blade screwdriver or a coin.
This screw is required when transporting the unit again. Please keep it (see page 32).

! Aerial connection

FM/AM loop aerial:
Connect the FM/AM loop aerial to the ANTENNA socket.
Position the FM aerial wire and rotate the AM loop aerial for optimum reception.
Place the AM loop aerial on a shelf, or attach it to a stand or a wall.
Notes:
" Placing the aerial on the stereo system or near the AC power lead may cause
noise pickup. Place the aerial away from the stereo system for better reception.
" If the AM loop aerial and the FM aerial wire are placed near the AC power lead,
interference may result.
" Do not connect the attached FM aerial to an external FM aerial. Otherwise, trouble
may occur.
Installing the AM loop aerial:
Assembling Attaching to the wall

! Speaker connection

Main terminals:
Connect the blue wire to the (+) and the black one to the (-).
Subwoofer terminals:
Connect the red wire to the (+) and the black one to the (-).
Caution:
" Connect the speaker wires to the speakers first, then to the unit.
" Never mistake the MAIN and the SUBWOOFER terminals. The stereo system or
the speakers may be damaged.
" Only the included speakers should be used with this product. Do not use other
speakers with this unit or use the supplied speakers with other units.
" Do not mistake the right channel for the left channel when connecting the speak-
ers to the unit. The right speaker is the one on the right side when you are facing
the front of the unit.
" Do not let the bare speaker wires touch each other.
Wall Screws
" Do not stand or sit on the speakers. You may be injured.
Right speaker
1
Blue Black Red
Incorrect
Demonstration mode (See page 14.)
01/1/25 E1.fm
Left speaker
2 3
Incorrect
ENGLISH E-10