Adjusting The Handles - DHG SystemRoMedic Bure Standard/S Manuel D'utilisation

4. Raising/Lowering the Frame - Electric
The desired height is adjusted with Arrow <UP> or Arrow <DOWN>.
Handset TiMOTION Plus also have charge indicator / battery (low, medium,
high) and Service indicator (see further under "17 Hand Control Plus").
5. Raising/Lowering the Frame - Gas
Release the gas strut by moving the handle upward (the gas strut will raise the
Walker). Let go of the handle at the desired height (the gas strut a locked).
Release the gas strut by moving the handle upward. Use your body weight to
press the frame down. Let go of the handle at the desired height (the gas strut
will lock).

6. Adjusting the Handles

To adjust handles to the desired position; undo knob,
adjust handle, tighten knob.
7. Left and Right Adjustment of Armrests
The armrests can be adjusted sideways for optimal
support; undo knob, adjust armrest, tighten knob.
8. Locking/Unlocking Castors
Depress the foot brake to set it and lock the castor.
Press down on the protruding part of the brake to release it.
9. Control Box Wiring
Remove the control box cover to make the connections as described
below. Use a screwdriver or similar; refer to the special labels on the
control box.
NOTE: Make sure that plugs are connected to the correct sockets
otherwise the actuators can be damaged.
1. Socket for the raise/lower actuator.
2. Hand control socket.
3. Battery terminal socket.
4. Plug socket. NOTE: The plug must ALWAYS be connected to the
control box for IP protection to be valid.
I F U
1
2
3
4
7