DHG SystemRoMedic Bure Standard/S Manuel D'utilisation page 5

Warnings
The caregiver must be able to read and understand the Manual/IFU of the product.
It is important to use only approved accessories to prevent unintended detachment of components and
subsequently a fall that may lead to patient injury.
Use careful and gentle maneuvers when moving the device.
Perform maintenance/service of the device, according to the instructions in the manual/IFU, at least once every
12 months.
Accessories must be properly fitted and tested in relation to the user's needs and functional ability.
Special care must be taken when using strong electrical power sources such as diathermy and the like so that
diathermy cables are not placed on or near the device. In case of doubt consult with a Direct Healthcare Group
representative.
When lifting the device, only use the denoted handholds. At least two people are required for lifting the device.
Do not leave a care recipient unattended during a transfer.
Never move the lift by pulling on the actuator or gas piston.
The device must not be lowered into water.
The device must not be cleaned using steam.
The device must not be left or stored in a damp or humid environment.
The device must not be charged in a wet room.
The device must not be used outdoors, only indoors.
To avoid the risk of electric shock, this equipment must only be conected to a supply mains with protective earth.
No modification of this equipment is allowed
Do not modify this equipment without authorisation of the manfacturer
If this equipment is modified, appropriate inspection and testing must be conducted to ensure continued safe
use of this equipment.
Before use:
• Inspect the packaging for any damage.
• Check for correct product being delivered.
• Check to ensure that the device is free from damage.
• Check if all the parts/components are included in the packaging.
• Check if all approved accessories are included in the package.
• Check if Product Quality Approval document is included in the packaging. Save this document for future contact
with manufacturer.
• Make certain the device is properly assembled.
• Check lifting function and bottom-frame adjustment function.
• Check if it is possible to move the device in all directions.
I F U 5