Storage And Transportation - DHG SystemRoMedic Bure Standard/S Manuel D'utilisation

13. General Maintenance Advice & Cleaning of Walker
• Clean the walker armrests and handles after every use. Wipe using a mild soap solution/surface disinfectant.
However, the product is not corrosion proof.
• With enviroments with high risk of infections use the walker with PU-cushions (Accessory number 57-361-L
and 57-361-R)
• Replace damaged parts immediately; must be done by experienced personnel.
• The product is only intended for indoor use.
14. General Maintence for gait training Sling:
Read the product label.

15. Storage and transportation

If the walker is not to be used for some time or e.g., during transport, we recommend that the emergency stop
button be pressed in. The walker should be transported and stored in -10 ° C to + 50 ° C and in normal humidity,
20% to 80% non-condensing. The air pressure should be between 700 and 1060 hPa. Leftmost symbol indicates
storage and transportation. Let the walker reach room temperature before the batteries are charged or the walker is
used. The walker should not be stored so that it is exposed to dust, or so that the battery or gas piston is exposed
to direct sunlight.
Operation
The operating environment should be 5 °C to 40°C, relative humidity 20% to 80% non-condensing, and atmo-
spheric pressure 700 to 1060 hPa. See also Technical Information below. Leftmost symbol indicates operating
condition.
10
Do not use rinsing agent.
To prolong product life,
avoid tumble-drying.
I F U