Connecting The Stereo - Sony LBT-V3500 Mode D'emploi

Connecting the Stereo

Use the illustrations below to connect your
stereo.
If you want to connect any optional
components to the stereo, see "Connecting
Optional Equipment" in Chapter 7.
STEP 1 Connecting the
Front Speakers
1 Twist the speaker cable coating and pull
it from the end of the cable.
2 Connect the right speaker to (FRONT*)
SPEAKER R connectors and the left
speaker to (FRONT*) SPEAKER L
connectors with the red cord to + and
the black cord to –.
red
black
Connect this portion
* LBT-V4500 only
STEP 2 Connecting a
Super Woofer (LBT-V4500
only)
Connect the Super Woofer to the SUPER
WOOFER R and L connectors with the blue
cord to + and the black cord to –.
blue
black
Connect this portion
STEP 3 Connecting the
Aerial
AM loop
aerial
(supplied)
FM wire aerial* (supplied)
*Note: Extend it horizontally
To set up the AM loop aerial
To improve the FM reception
Connect an outdoor FM aerial to the FM 75
Ω terminal, using a 75-ohm coaxial cable.
Important
Ground the external aerial from y terminal
against lightning with the screw clamp. To
prevent a gas explosion, do not connect the
ground wire to a gas pipe.
75-ohm coaxial cable
(not supplied)
To improve the AM reception
After you connect the AM aerial, connect a
6- to 15- meter (20- to 50- feet) insulated
wire to the AM terminal. Connect the y
terminal to ground.
Important
Ground the external aerial from y terminal
against lightning with the screw clamp. To
prevent a gas explosion, do not connect the
A M
ground wire to a gas pipe.
F M 7
5
Insulated wire (not
supplied)
Ground wire
(not supplied)
continue to next page
Chapter 1: Setting Up
screw clamp
A M
F M 7
5
Ground wire
(not supplied)
EN
5
screw clamp
A M
F M 7
5