Publicité
Les langues disponibles
Les langues disponibles
Stainless steel hose clamp.
T of 135° with outlet.
Elbow of 45°.
Wooden ground.
Non flammable floor protection.
Stainless steel flexible tube.
Rigid flexible pole adapter.
Minimum 200mm.
It must exceed roof height by 1 metre.
If the tube over 4 m in length, the next larger
size will be used.
4.28. Installing a fitted stove in a brickwork chimney can be done using flexible piping in its entirety, as indicated in
drawing 15. We must take special care when sealing the chimney and gas venting to avoid gas blowing back
during storms.
Stainless steel hose clamp.
T of 135° with outlet.
Elbow of 45°.
Wooden ground.
Non flammable floor protection.
Stainless steel flexible tube.
Rigid flexible pole adapter.
Anti blow-back seal.
Minimum 200mm.
It must exceed roof height by 1 metre.
If the tube over 4 m in length, the next larger
size will be used.
When installing a flexible tube for gas outlet, be careful that this is not in contact or close to the circuit board
or combustible material.
RECOMMENDATIONS ON THE CHANNELING OF CONVECTION AIR.
The 2 first meters of the pipe must be done in stainless steel.
Convection air must always travel through insulated pipelines.
The maximum length for all pipes channeling air is of 7 meters. If the user needs longer pipes, he/she must
install an additional ventilation motor (see the diagram detailing the different parts).
Stove models Venecia and Ibiza have Ø116cm supply air duct systems. If the user choses not to channel
convection air through a pipeline, the supply air duct system (
DUBAI, IBIZA, VENECIA, BOSTON Y KIEV MODELS.
38
) can be replaced for direct vertical exits (
Drawing 14
Drawing 15
) (see
Publicité
