ECOFOREST IBIZA Manuel D'installation Et Maintenance page 33

IN CASE OF SOOT FIRE:
The stove must be shut down.

Call fire brigade.

The stove must be tested by Chimeney's sweeps after the soot fire, before it is reused.

3. FUEL QUALITY.
Your stove is designed to operate with wood pellets; however, it can also work with other biomass fuels (ask
your dealer about this). Many types of pellets are sold on the market, with very different quality levels. For this
reason, it is very important to choose pellets free from dirt, with no excessive level of damp nor additives that
compact sawdust.
The stove output may vary depending on the type of pellets you use.
ECOFOREST do not have any control on the quality of the pellets you use. For this reason, ECOFOREST cannot
guarantee the full output of your stove nor the eventual premature aging or eventual damage of the gas outlet. It is
recommended to use ECOFOREST pellets which are approved as per European standard DIN 51731 and
distinguished by the logo of ECOFOREST printed on the 15kg bags.
If you use other biomass fuels, please note that the stove's operating parameters and, in most cases, the
combustion grate, are not the same as those used for wood pellets. Before burning any fuel other than wood pellets,
consult your dealer on whether the desired type of fuel can be used, as well as the requirements it should meet,
and/or the type of grate necessary.
4. INSTALLATION.
The below security distances and assembly diagrams are given for information only as an adaptation shall be
made depending on the norms in force regarding gas outlet, power, security minimum distances specific to
geographic areas.
The installation of the stoves must be done in the same way, for this reason, only the KIEV model will be
exposed. In the same way, air inlets will be missed in all drawings as section 4.12 indicates the minimum security
distances to be respected for their installation.
4.1. Remove the packaging and the protective plastic.
4.2. Remove the screws or bolts that fasten the stove to the pallet and remove it.
4.3. If our model has a plastic protection, it must be removed before starting it.
4.4. Remove exhaust blower protection.
UNPACKING THE STOVE.
Drawing 5
32