Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
OPERATION
1. Before use
• Remove any packing material and loose parts from unit.
• Check the accessories before use. It should be fit with the machine and your
purpose.
• If the machine is new, the battery must first be charged.
Attention! After long time storage, the battery capacity will be reduced.
A new battery or one which has not been used for an extended period achieves full
performance only after approx. 5 charging and discharging cycles. A substantial
drop in operating period per charge indicates that the battery is worn out.
2. Battery charger
The Lithium-Ion battery can be charged at any time and will not develop a
"memory" when charged after only a partial discharge.This tool is shipped with
one battery inside which has been partially charged.Before using it the first time,
fully charge the battery. A fully discharged battery with a temperature between 0°C
and 40°C will charge in about 2-3 h.
a. Charging the battery with AC power supply (fig.1)
b
a
fig. 1
Warning! Only use the delivered charger for charging.
- Check that your mains voltage is same as that
marked on the rating plate of the battery charger
(8).
- Insert the USB plug (a) of USB line into the battery
charger.
- Plug the charger into the AC socket.
- Insert the phone jack (b) of USB line into the
charging socket (6) on the tool. Then the charging
is in process.
Publicité
Table des Matières
