Proper Use; Remaining Hazards - Scheppach bg 150 Traduction Du Manuel D'origine

IMPORTANT NOTE:
• Hold on to small work pieces with a pair of pliers or
similar tool.
• Never grind on the side of the wheels!
• As most materials gain heat while being grinded please
be careful with the work piece.
CHANGING THE GRINDING WHEELS
IMPORTANT NOTE: In order to prevent injuries from acci-
dentally starting the machine the machine's main switch
must be turned off before changing a grinding wheel. Pull
power plug!
• Loosen the spark gard and the eye shield and pull out
• as far as possible. Do not remove these parts!
• Loosen work rest and pull out as far as possible.
• Dissemble screws and pull off end plate.
• Take off outside flange and the old grinding wheel, then
assmeble the new one.
Important note:
• Do not remove the pieces of card board on the sides of
the wheel, as they are intended for strengthening the
grip of the Flange against the grinding wheels.
• Examine the new grinding wheels on cracks or other
visible damages and dispose if necessary.
• Mount flange and nut again.
• Do not tighten the screw by force. This can cause the
grinding wheel to break.
• Mount end plate.
• Mount work rest, spark guard and eye shield according
to installation instructions.
m Proper Use
The machine meets the currently valid EU machine
• The manufacturer's safety, operation and maintenance
instructions as well as the technical data given in the
calibrations and dimensions must be adhered to.
• Relevant accident prevention regulations and other gen-
erally recognized safety and technical rules must also
be adhered to.
• The machine may only be used, maintained or repaired
by trained persons who are familiar with the machine
and have been informed about the dangers. Unauthor-
ized modifications of the machine exclude a liability
of the manufacturer for damages resulting from the
modifications.
• The machine is intended for use only with original spare
parts and original tools from the producer.
• Any other use is considered to be not intended. The
manufacturer excludes any liability for resulting dam-
ages, the risk is exclusively borne by the user.
m Remaining hazards
The machine has been built using modern technology and
in accordance with recognized safety rules. Some hazards,
however, may still remain.
• The grinding wheel poses a danger of injury to fingers
and hands by improper feeding or placement of tools.
• Danger of injury from thrown tools due to improper
holding or feeding.
• The use of incorrect or damaged mains cables can lead
to electrical injuries.
• Although having regarded all considerable rules there
may still remain not obvious remaining hazrds.
• Minimize remaining hazards by following the instruc-
tions in "Safety Rules", "Use only as authorized" and
8 english
in the entire operating manual.
directive.