Installation Instructions - Danby DKC5811BSL-2 Guide D'utilisation Et D'entretien

Installation Instructions

BEFORE PUTTING
THE APPLIANCE
INTO USE
• Ensure that all included accessories are present and in good condition.
• Make sure you have read and understood all important safety information.
INSTALLATION OF
BEER DISPENSER
ELECTRICAL
CONNECTION
Improper use of the grounded plug can result in the risk of electrical shock. If the
power cord is damaged, have it replaced by an authorized service center.
• Before plugging in the keg cooler, let it stand upright for approximately 2
hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
IMPORTANT
• This appliance is designed to be free standing only, and should not be
recessed or built-in.
• Place your Beer Dispenser on a floor that is strong enough to support the
Beer Dispenser when it is fully loaded.
• Allow 3 inches of space between the back and sides of the Beer
Dispenser, which allows the proper air circulation to cool the compressor.
• Locate the Beer Dispenser away from direct sunlight and sources of heat
(stove, heater, radiator, etc.). Direct sunlight may affect the acrylic coating
and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the Beer Dispenser not to perform
properly. This unit is not designed for outside installation, including
installation anywhere that is not temperature controlled (including
garages, porches, carports, etc.).
• Avoid locating the Beer Dispenser in excessive humidity.
• Plug the Beer Dispenser into a dedicated, properly installed-grounded wall
outlet. Do not under any circumstances cut or remove the third (ground)
prong from the power cord. Any questions concerning power and or
grounding should be directed toward a certified electrician or an
authorized service center.
• After plugging the appliance into a wall outlet, allow the unit to cool down
for 2-3 hours before placing any contents in the Beer Dispenser
compartment.
WARNING
This Beer Dispenser should be properly grounded for your safety. The power
cord of this Beer Dispenser is equipped with a three-prong plug which mates
with standard three prong wall outlets to minimize the possibility of electrical
shock.
Do not under any circumstances cut or remove the third ground prong from
the power cord supplied.
Use of extension cords is not recommended.
6