Important Safety Information; Electrical Requirements; Important Warning; Installation Instructions - Danby DFF344WDB Guide D'utilisation Et Soins De Propriètaire

Important Safety Information

READ AND FOLLOW ALL SAFETY INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of
electrical shock by providing an escape wire for the electrical current.
ELECTRICAL
REQUIREMENTS
Leave Shelves Inside and
remove doors.

Installation Instructions

Bottom of Unit
Use pliers or wrench to
adjust the leveling legs
Leveling Legs
Turn clockwise
to lower the unit
Fig.1.
This appliance is equipped with a cord having a grounding wire with a
grounding plug. The plug must be plugged into an outlet that is properly
installed and grounded.
An empty refrigerator is a very dangerous attraction to children.
Remove either the gasket or lid from unused appliances, or take
some other action that will guarantee it harmless.
Improper use of the grounding plug can result in a risk of electric
shock. Consult a qualified electrician or serviceman if the ground-
ing instructions are not completely understood, or if doubt exists
as to whether the appliance is properly grounded.
DO NOT USE AN EXTENSION CORD
Use an exclusive wall outlet. Do not connect your refrigerator to exten-
sion cords or together with any other appliance in the same wall outlet.
DANGER:
refrigerator or freezer:
• Take off the doors.
• Leave the shelves in place so that children may not easily climb in.
Remove exterior and interior packing, wipe the outside thoroughly with a
soft dry cloth and the inside with a wet, lukewarm cloth. Avoid placing the
unit in a narrow recess or near any heat source, direct sunlight, or mois-
ture. Let air circulate freely around the unit. Keep the rear of the refrigera-
tor 5 inches away from the wall.
LOCATION
1) Select a place with a strong, level floor.
2) Allow 5 inches of space between a wall and the back of the refrigerator,
and 1 to 2 inches of space between a wall and a refrigerator side.
3) Avoid direct sunlight and heat. Direct sunlight may affect the acrylic
coating on the refrigerator exterior. Heat sources nearby will cause
Turn counter-
higher electricity consumption.
clockwise to
raise the unit.
The refrigerating system in this refrigerator is a "Frost Free" system. This
type of system requires no user intervention (i.e. defrosting) other than
selecting required cooling temperatures and the usual care and
maintenance.
To avoid vibration, the unit must be set level. This is accomplished by
adjusting the (2) front leveling legs, located under the refrigerator. (Fig 1)

IMPORTANT WARNING

WARNING
Risk off child entrapment. Before you throw away your old
DON'T WAIT DO IT NOW!
2