Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
TOOLS YOU
WILL NEED
WARNING: While performing the
installations described in this section;
gloves and safety glasses or goggles
should be worn.
PREPARING THE
ENCLOSURE
• It is recommended that you do not install the wine and beverage center into a corner (i.e. directly beside a wall).
This is to allow the door to have a greater than 90° opening swing. A limited door swing will prevent the shelves
from sliding out as intended, and may lead to damaging the door gasket.
• The rough cabinet opening must be on a level floor area and at least 26 7 /8" (68.26cm) deep* by 23 3 /4" (60.33cm) wide.
The opening should also have a height of at least 70 1/16" (178cm).
• The electrical outlet may be positioned from within either side of the adjacent cabinetry, or the rear of the
shaded area (as shown in Fig. B).
Important: If the electrical outlet is surface mounted (not flush) within the enclosure, the depth requirement
for the installation may be affected.
• If the electrical outlet is located inside the adjacent cabinetry, cut a 1 1 /2" (3.81cm) diameter hole to admit
the power cord.
IMPORTANT:
DOOR SWING
Fig. B: The listed depth requirement for the installation is
assuming that the electrical outlet is located in the adjacent
cabinetry or is flush mounted in the rear wall, not surface
mounted in the enclosure.
INSTALLATION INSTRUCTIONS
Safety Glasses
Drill & Hole Saw set
Electrical Requirements: The appliance must be connected to an individual,
properly grounded electrical outlet, protected by a 15 or 20 ampere circuit breaker
or time delay fuse.
IMPORTANT: Do not include the door within the enclosure; leave it outside of the
enclosure to prevent the door swing from being obstructed.
Gloves
Measuring
Tape
70 1/16"/
Fig. B
178cm
Electrical
Access: 2" /
23
3
Level
Flashlight
Carpenter's
Square
7 /8 "*
26
/
68.26cm
Cabinets
must be
square
3.81cm
and
plumb.
3 /4 "
/ 60.33cm
Publicité
Table des Matières
