Installation Instructions - Danby DUF206E1SSLDB Manuel Du Propriétaire

Réfrigérateur et congélateur vertical convertible
Masquer les pouces Voir aussi pour DUF206E1SSLDB:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION INSTRUCTIONS

LOCATION
• Two people should be used when moving the
appliance.
• Remove interior and exterior packaging prior to
installation. Wipe the outside of the appliance
with a soft, dry cloth and the inside with a
lukewarm wet cloth.
• Place the appliance on a fl oor that is strong
enough to support it when it is fully loaded.
• Do not place the appliance in direct sunlight or
near sources of heat, such as a stove or heater,
as this can increase electrical consumption.
Extreme cold ambient temperatures may also
cause the appliance to perform improperly.
• Do not use the appliance near water, for
example in a wet basement or near a sink.
• This appliance is intended for indoor household
and garage use only. Freezers are tested to
perform in temperatures ranging from 0°F to
110°F (-17°C to 43°C). It is not designed for
outside installation, including anywhere that
is not temperature controlled such as porches,
vehicles, etc.
• Before connecting the appliance to a power
source, let it stand upright for approximately
6 hours. This will reduce the possibility of a
malfunction in the cooling system from handling
during transportation.
• This appliance is 83.2 cm (32.8 inches) wide
by 195 cm (76.8 inches) high by 73.5 cm (29
inches) deep.
• Allow 12.7 cm (5 inches) of space between the
back, sides and top of the appliance and all
adjacent walls.
• This appliance is intended for free-standing
installation only and is not intended to be
built into a cabinet or counter. Building in this
appliance can cause it to malfunction.
OPERATING INSTRUCTIONS
FEATURES
1. Light switch
2. Airfl ow Outlet
3. Glass shelves
4. Airfl ow Inlet
5. Plastic drawers
6. Door Shelf
7. Adjustable Foot
2
3
4
5
LEVELING INSTRUCTIONS
There is an adjustable foot on the bottom of the
appliance that can be turned up or down to ensure
that the appliance is level.
1. Turn the adjustable foot counter-clockwise as far
as it will go, until the top of the foot is touching
the bottom of the cabinet.
2. Slowly turn the adjustable foot clockwise until the
appliance is level.
3
1
6
7

Publicité

Table des Matières
loading

Table des Matières