Danby DKC5811BSL-2 Guide D'utilisation Et D'entretien page 13

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Beer Keg Installation Instructions
SPANNER FAUCET
WRENCH
PLASTIC FAUCET
LEVER
DISPENSING OF BEER
Spanner faucet wrench is provided for either removing or tightening
connection.
Note: To prevent leakage, use the provided wrench to further tighten
the faucet.
Attach the black plastic lever (pull handle) to the top of the faucet by
tightening it by hand clockwise until the end, holding in the silver nut
underneath so it does not turn. If there is still a small drip from the faucet,
you may have tightened the plastic lever too much and may need to
unscrew silver snug counter-clockwise (as shown) one turn.
• Keep beer keg refrigerated at all times.
• Never allow beer lines to dry out.
• Use clean beer glassware before pouring.
• Hold glass at a 45° angle when 2/3 full, start to straighten glass as the
glass fills.
• Always make sure the faucet handle is pushed all the way back.
Note: Keg sizes that can be used in your beer dispenser
1/2 barrel
59 Liters
15.5 gals
1/4 barrel
30 Liters
7.8 gals.
1/6 barrel
20 Liters
5.2 gals.
1/8 barrel
15 Liters
4.0 gals.
Note: Our Beer dispenser accepts standard kegs up to 16-1/8" in
diameter, and up to 23-3/8" in height. Check with your distributor to make
sure keg is correct size.
11
1984 oz.
164/12-oz. Glass
992 oz.
82/12-oz. Glass
661 oz.
55/ 12-oz. Glass
496 oz.
41/ 12-oz. Glass

Publicité

Table des Matières
loading

Table des Matières