Installing The Ax16-At - Yamaha AX16-AT Mode D'emploi

Installing the AX16-AT

The AX16-AT installs into a single PCI or ISA expansion slot and requires no
special jumper settings or interrupt settings. If you are installing in an ISA
slot, see "Fitting the ISA-bus Mounting Bracket" on page 10 before continu-
ing with this procedure.
See your computer's manual for full details on installing cards.
Turn off the computer and disconnect the power cord.
1
Remove the computer's cover.
2
Choose an empty slot for the AX16-AT, and remove the expan-
3
sion-slot cover.
To prevent static electricity from damaging the AX16-AT, touch a grounded
metal part of your computer, such as the power supply case, before handling
it.
Carefully align and insert the AX16-AT into the slot.
4
ISA
If the expansion-slot cover was held in place by a screw, secure the
5
AX16-AT using the same screw.
Important: Tighten the expansion-slot fixing screw so that the AX16-AT can-
not jiggle about in the slot.
PCI
Installing the AX16-AT
AX16-AT—Owner's Manual
9