Built-In Grill Cut-Out Dimensions To Install Into Combustible Enclosures With Grill Liner Accessory; Built-In Outdoor Grill Enclosure Ventilation - Monogram ZGG420NB Instructions D'installation

BUILT-IN GRILL CUT-OUT DIMENSIONS TO INSTALL INTO COMBUSTIBLE ENCLOSURES
WITH GRILL LINER ACCESSORY (not provided with built-in grill)
Description Model
30" Grill Liner ZX30JR
42" Grill Liner ZX42JR
54" Grill Liner ZX54JR

BUILT-IN OUTDOOR GRILL ENCLOSURE VENTILATION

All enclosures must have ventilation holes to prevent gas
build-up in the event of a leak.
The enclosure shall have one side completely open or, at
a minimum, shall meet the requirements in ANSI Z21.58
for grill enclosures.
• Enclosure must have openings on 2 of the sides to
ensure that air flows through the enclosure
• Must have at least 2 ventilation openings within 1.5" of
the bottom floor and each be a minimum of 10 in
0.5 in /lb. of stored fuel capacity, whichever is greater.
2
• Must have at least 2 ventilation openings approximately
4" from the top and each be a minimum of 20 in
1 in /lb. of stored fuel capacity, whichever is greater.
2
• All openings shall be unobstructed and be a minimum
of 1/8" wide.
• Ventilation openings must be kept free and clear of debris.
31-11026
Installation Preparation
Dimensions with
Insulated Jacket Installed
a b c d e
36" 5" 26½" 4½" 3
48" 5" 26½" 4½" 3
60" 5" 26½" 4½" 3
4" square
holes for gas
and electrical
connections both
left and right
sides (rear or
bottom access).
Make these holes
in the frame
based on your
requirements.
or
2
or
2
f
Approx. 4"
Max 1.5"
Grill
Insulated
Liner
Combustible
Enclosure
Approx. 4"
Max 1.5"
9