Outdoor Grill, Cooktop And Accessory Cutout Dimensions - Monogram ZGG420NB Instructions D'installation

Tables de cuisson et barbecues de plein air professionnels
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OUTDOOR GRILL, COOKTOP AND ACCESSORY CUTOUT DIMENSIONS

28-3/4" for 30" Models
40-3/4" for 42" Models
52-3/4" for 54" Models
24-1/2"
36"
Min.
Gas and Electrical Locations
3-1/2"
7-3/8"
3-1/2" Dia. Hole
3-1/2" Dia. Hole
for Stationary
for LP Tank Hose
Gas Line
• If the countertop has an overhang, it must be notched or
cut back flush with the front face of the cabinet below. This
will allow the grill or side burner to fit flush at the front.
Countertop Notch Detail
5/8" for Grills
9/16" for Outdoor Cooktop
8
Installation Preparation
12" Min. Separation
Between Cutouts
24-1/2"
Grill Cutout
10-7/8"
Access Doors
18-1/4"
1-1/8"
ZX27AD
Min.
24-1/8"
GAS LOCATION:
10" Min.
Cut a 3-1/2" dia.
hole for the manifold
3-1/2"
connection as
shown for LP tank or
stationary gas line
connections.
ELECTRICAL
2"
LOCATION:
Cut a 1" dia. hole at
the back left side of
the cutout.
Gas and Electrical Locations
Non-Combustible
*See Note.
*
Note: When installing more than one accessory below the countertop, align the accessories
across the bottom by adjusting the dimension above the floor. The cutouts must be offset
depending on the product overlap below the cutout. Overlap for ZX27AD is 7/8".
Note: When installing into combustible material, Built-In Monogram Outdoor Grills
require the use of a grill liner. Refer to Grill Liner Installations Instructions for installation
requirements.
• The grill drops into the opening and hangs from the side
flanges. A deck is not required for support on the bottom.
• The construction must be level and stable and capable
of supporting up to 400 lbs.
• The opening for the cooktop must be 24-1/2" deep from
the front of the countertop. Cut a 1" dia. hole below the
cooktop for the drain hose.
• Cut a 1" dia. hole at the back left side of the cutout
for the grill's electrical connection.
• A 120 volt outlet must be located within reach of the grill's
6' power cord. The transformer bracket must be mounted
within 3-1/2 feet of the outdoor grill.
• Maintain 12" separation between cutouts for an outdoor
grill and an outdoor cooktop installation.
The grill rotisserie connection is on the left side near
the front. Installation into a 24-1/2" front-to-back
opening allows access to the rotisserie outlet.
Rotisserie
Connection
Non-Combustible
31-11026

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zgg420lbZgg300nbZgg300lb

Table des Matières