To Start The Engine - Husqvarna 135R Manuel D'utilisation

2. Hold the product as shown in the illustration.
3. Use the strap on the harness to adjust the height of
the support hook.
To prepare for grass clearing
1. Apply support to the product with the harness during
grass clearing.
2. Make sure that the cutting equipment is parallel to
the ground.
Correct balance of the product
For forestry clearing, the product is correctly balanced
when it freely hangs horizontally from the suspension
point. With correct balance, the risk of hitting stones if
you release the handlebar is decreased.
For grass clearing, the product is correctly balanced
when the blade is at cutting height near the ground.
16

To start the engine

WARNING: Keep a minimum distance of 15
m/50 ft from persons or animals when you
start the product. There is a risk that the
cutting attachment starts to move.
1. Set the stop switch in the start position.
2. Set the choke control in the choke position.
3. Push the air purge bulb until the bulb starts to fill with
fuel.
Note: It is not necessary to fill the air purge bulb fully.
4. Hold the body of the product on the ground with your
left hand. Do not put your feet on the product.
5. Pull the starter rope handle slowly until you feel
some resistance, then pull the starter rope handle
with force.
WARNING: Do not wind the starter rope
around your hand.
6. Continue to pull the starter rope handle until the
engine starts.
975 - 003 - 08.10.2019