Bevel Gear; Air Filter - Husqvarna 135R Manuel D'utilisation

1. Clean the cooling system with a brush weekly or
more frequently if it is necessary.
B
2. Make sure that the cooling system is not dirty or
blocked.

Bevel gear

The bevel gear is filled with the correct quantity of
grease at the factory. Before you use the product, make
sure that the bevel gear is 3/4 full of grease. Use
Husqvarna special grease.
The grease in the bevel gear is replaced by your
servicing dealer.

Air filter

Remove dust and dirt from the air filter to keep it clean in
order to prevent:
• Carburettor malfunctions.
• Starting problems.
• Loss of engine power.
• Unnecessary wear to engine parts.
• Too much fuel consumption.
Clean the air filter at an interval of 25 hours, or more
regularly if conditions are unusually dusty.
To clean the air filter
Clean the air filter regularly from dirt and dust. This
prevents carburetor malfunctions, starting problems,
22
C
A
loss of engine power, wear to engine parts and more
fuel consumption than usual.
• Clean the air filter at an interval of 25 hours, or more
regularly if you operate the product in conditions with
much dust.
To apply oil to the air filter
CAUTION: Always use Husqvarna special
air-filter oil. Do not use other types of oil.
WARNING: Put on protective gloves. The
air-filter oil can cause skin irritation.
1. Put the air filter in a plastic bag.
2. Put the oil in the plastic bag.
3. Rub the plastic bag to supply the oil equally across
the air filter.
4. Push the unwanted oil out of the air filter while in the
plastic bag.
To do a check of the spark plug
CAUTION: Use the recommended spark
plug. Refer to
An incorrect spark plug can cause damage
to the product.
1. If the product is not easy to start or to operate or if
the product operates incorrectly at idle speed,
examine the spark plug for unwanted materials. To
decrease the risk of unwanted material on the spark
plug electrodes, do these steps:
Technical data on page 25 .
975 - 003 - 08.10.2019