Operation - Husqvarna 135R Manuel D'utilisation

To assemble the guard and trimmer head/
plastic blades
CAUTION: Make sure that the guard
extension is assembled.
1. Install the trimmer guard/cutting attachment guard
(A) intended for operation with the trimmer head/
plastic blades.
2. Hang the trimmer guard/cutting attachment guard (A)
on the two hooks on the plate holder (M).
3. Bend the guard around the shaft and tighten it with
the bolt (L) on the opposite side of the shaft. Use the
locking pin (C).
4. Put the locking pin in the groove on the screw head
and tighten.
M
A
5. Install the drive disc (B) on the output shaft.
H
B
C
M
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain, the slope of the ground and if
975 - 003 - 08.10.2019
L
C
A
L

Operation

6. Turn the output shaft until 1 of the holes in the drive
disc aligns with the related hole in the gear housing.
7. Put the locking pin (C) in the hole to lock the shaft.
8. Install the trimmer head/plastic blades (H)
counterclockwise.
H
9. To disassemble the trimmer head/plastic blades,
follow the instructions in the opposite sequence.
To assemble the shoulder harness
1. Put the ring of the shoulder harness strap through
the hook (A) and attach it with the bolt.
2. Attach the hook (B) of the shoulder strap to the ring
(C) on the frame.
A
To adjust the shoulder harness
1. Stop the engine.
2. Put on the harness.
3. Adjust the shoulder strap to make the product weigh
equally on your shoulders.
there are obstacles such as stones, branches and
ditches.
• Do an overhaul inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged.
H
C
B
13