Symbols On The Product - Husqvarna 135R Manuel D'utilisation

7. Throttle trigger
8. Stop switch
9. Throttle trigger lockout
10. Suspension ring
11. Cylinder cover
12. Starter rope handle
13. Fuel tank
14. Choke control
15. Primer bulb
16. Air filter cover
17. Handle adjustment
18. Locknut
19. Support flange
20. Support cup
21. Drive disc
22. Blade
23. Operator's manual
24. Transport guard
25. Locking pin
26. Harness
27. Spark plug cap and spark plug
28. Start throttle button
29. Throttle wire adjustment
30. Combination wrench
31. Guard extension

Symbols on the product

WARNING! This product is dangerous.
Injury or death can occur to the operator or
bystanders if the product is not used
carefully and correctly. To prevent injury to
the operator or bystanders, read and obey
all safety instructions in the operator's
manual.
Read the operator's manual carefully and
make sure that you understand the
instructions before use.
Use a protective helmet in locations where
objects can fall on you. Use approved
hearing protection and approved eye
protection.
Use approved protective gloves.
Use heavy-duty slip-resistant boots.
975 - 003 - 08.10.2019
The product can cause objects to eject,
which can cause injury.
Maximum speed of the output shaft.
Keep a minimum distance of 15 m / 50 ft.. to
persons and animals during operation of the
product.
Risk of blade thrust if the cutting equipment
touches an object that it does not
immediately cut. The product can cut off
body parts. Keep a minimum of 15 m / 50 ft.
distance to persons and animals during
operation of the product.
Only use a flexible cutting wire. Do not use
metal cutting elements. Apply this for grass
guard accessory.
The arrows shows the limit for the handle
position.
Air purge bulb.
Choke.
yyyywwxxxx The rating plate shows the serial
number. yyyy is the production year
and ww is the production week.
Note: Other symbols/decals on the product refer to
certification requirements for other commercial areas.
EPA III
3