Husqvarna 135R Manuel D'utilisation page 12

2. Put the guard extension into position on the cutting
attachment guard with the 4 locking hooks.
To remove the guard extension
• Release the locking hooks with the spark plug
wrench.
To attach the grass blade and the grass blade
guard/combination guard
1. Put the blade guard/combination guard (A) onto the
shaft and tighten the bolt to attach it.
2. Make sure that the guard extension is removed.
3. Turn the output shaft to align one of the holes in the
drive disc (B) with the related hole in the gear
housing.
4. Put the locking pin (C) in the hole to lock the shaft.
5. Put the grass blade (D), the support cup (E) and the
support flange (F) on the output shaft.
D
C
A
12
A
G
E
F
B
6. Make sure that the drive disc and support flange
engages correctly in the centre hole of the grass
blade.
7. Attach the nut (G).
8. Tighten the nut with the socket wrench. Hold the
shaft of the socket wrench near the blade guard.
Tighten in the opposite direction to how the cutting
attachment rotates. Tighten it to a torque of 35-50
Nm.
To install the blade guard
CAUTION: Only use the approved guard for
the blades. Refer to
25 .
1. Remove the bracket (H).
2. Attach the adapter (I) and bracket (J) with the 2
screws (K).
3. Attach the blade guard (A) to the adapter with the 4
screws (L).
H
Accessories on page
J K
I
L
A
975 - 003 - 08.10.2019