Connecting The Power Cord (1) - Pioneer AVIC-X3II Manuel D'installation

Section
03 Connecting the System

Connecting the power cord (1)

Note
Depending on the kind of vehicle, the function
of *3 and *5 may be different. In this case, be
sure to connect *2 to *5 and *4 to *3.
Cap (*1)
When not using this terminal,
do not remove the cap.
ISO connector
Note
In some vehicles, the ISO connector
may be divided into two. In this
case, be sure to connect to both
connectors.
10
Engb
*1
*3 *2
*5 *4
Yellow (*3)
Yellow (*2)
Back-up
To terminal always supplied
(or accessory)
with power regardless of
ignition switch position.
Red (*4)
Red (*5)
Accessory To electric terminal controlled by
ignition switch (12 V DC) ON/OFF.
(or back-up)
Orange/White
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Notes
• When a subwoofer (*8) is connected to this
navigation system instead of a rear speaker,
change the rear output setting in the Initial Setting.
(Refer to the operation manual.) The subwoofer
output of this navigation system is monaural.
• When using a subwoofer of 70 W (2 Ω), be sure to
connect with violet and violet/black leads of this
navigation system. Do not connect anything with
green and green/black leads.
Connect leads of the
same colour to each
other.
Fuse holder
Fuse (10 A)
Speaker leads
White: Front left
White/Black: Front left
Grey: Front right
Grey/Black: Front right
Green: Rear left
Green/Black: Rear left
Violet: Rear right
Violet/Black: Rear right
Fuse resistor
Fuse resistor
or Subwoofer (*8)
or Subwoofer (*8)
or Subwoofer (*8)
or Subwoofer (*8)