Pioneer AVIC-X3II Manuel D'installation page 13

Connecting the System
30 cm
Power cord
WARNING
LIGHT GREEN LEAD AT POWER CONNECTOR IS
DESIGNED TO DETECT PARKED STATUS AND MUST BE
CONNECTED TO THE POWER SUPPLY SIDE OF THE
HANDBRAKE SWITCH. IMPROPER CONNECTION OR
USE OF THIS LEAD MAY VIOLATE APPLICABLE LAW
AND MAY RESULT IN SERIOUS INJURY OR DAMAGE.
5 m
Yellow/Black (GUIDE ON)
The display unit
When combining this navigation system with the other
Pioneer audio unit for the vehicle, if the vehicle stereo has
yellow/black leads, connect them to those leads. In this way,
the vehicle stereo is automatically muted to reduce the vehicle
stereo volume when;
— the guidance audio is output.
— the mobile phone is used via Bluetooth adapter.
Light green (PARKING BRAKE)
Used to detect the ON/OFF status of the handbrake. This lead must be
connected to the power supply side of the handbrake switch.
If this connection is made incorrectly or omitted, certain functions of
your navigation system will be unusable.
Connection method
Clamp the lead.
Clamp firmly with
needle-nosed pliers.
Fuse resistor
Extension lead
(for reverse signal)
Check the position of your vehicle's
reversing lamp (the one that lights up
when the gearstick is in reverse [R])
and find the reversing lamp lead in
the boot.
Power supply side
Earth side
Handbrake switch
Reversing lamp lead
Section
03
13
Engb