Parts Supplied - Pioneer AVIC-X3II Manuel D'installation

Connecting the System
Notice for the blue/white lead
! When the ignition switch is turned on (ACC
ON), a control signal is output through the
blue/white lead. Connect to an external
power amp's system remote control term-
inal (max. 300 mA 12 V DC). The control sig-
nal is output through the blue/white lead,
even if the audio source is switched off.
! Do not connect this lead to the auto-aerial
relay control terminal or the aerial booster
power control terminal.
! Be sure not to use this lead as the power
supply lead for the external power amps.
Such connection could cause excessive
current drain and malfunction.

Parts supplied

The display unit
The hide-away unit
Extension lead
(for reverse signal)
30-pin cable
Connector
Power cord
Extension lead
(for speed signal)
GPS aerial
Extension aerial cable
Lock tie
Section
03
RCA connector
7
Engb