Connecting The Power Cord (1) - Pioneer AVIC-X1BT Manuel D'installation

Connecting the System

Connecting the power cord (1)

Note:
Depending on the kind of vehicle, the
function of *3 and *5 may be different.
In this case, be sure to connect *2 to *5
and *4 to *3.
*1
*3
*5
C a p ( * 1 )
When not using this terminal,
do not remove the cap.
Yellow (*3)
Back-up
(or accessory)
Red (*5)
Accessory
(or back-up)
ISO connector
Note:
In some vehicles, the ISO connector
may be divided into two. In this case,
be sure to connect to both connectors.
9
Bluetooth
adapter
(CD-BT10)
Yellow
To terminal always supplied
*2
with power regardless of
ignition switch position.
Black (earth)
*4
To vehicle (metal) body.
Yellow (*2)
To terminal always supplied
with power regardless of
ignition switch position.
Red (*4)
To electric terminal controlled
by ignition switch (12 V DC)
ON/OFF.
Orange/white
To lighting switch terminal.
Black (earth)
To vehicle (metal) body.
Speaker leads
White:
White/black: Front left ≠
Grey:
Grey/black: Front right ≠
Green:
Green/black: Rear left ≠ or Subwoofer ≠
Violet:
Violet/black: Rear right ≠ or Subwoofer ≠
Fuse (2 A)
Connect leads of the same
colour to each other.
Fuse (10 A)
Fuse resistor
Fuse resistor
Front left +
Front right +
Rear left + or Subwoofer +
Rear right + or Subwoofer +