After Installing This Product - Pioneer AVIC-X1BT Manuel D'installation

After Installing this Product

1. Reconnecting the battery.
First, double-check that all connections are correct and that this product is installed cor-
rectly. Reassemble all vehicle components that you previously removed. Then reconnect
the negative (–) cable to the negative (–) terminal of the battery.
2. Start the engine.
3. Press the RESET button.
• Press the RESET button on the display unit using a pointed object such as the tip of a
pen.
• Press the RESET button on the Bluetooth adapter using a pointed object such as the tip
of a pen.
4. Enter the following settings:
1. Install the programme in the navigation system.
2. Drive until the initialised sensors start operating normally.
3. Set the time and language.
Set the navigation system as explained in the Operation Manual or Hardware Manual.
Note:
If you reconnected the Hide-away unit, press the RESET button.
After installing this product, be sure to check at a safe place that the vehicle is per-
forming normally.
32