Control Panel; Gear Shift Lever - Milwaukee 4253-1 Manuel De L'utilisateur

Safety Chain
To reduce the risk of injury,always
WARNING
use a safety chain when drilling
overhead or on a vertical surface.
A safety chain is standard equipment with every
unit. Should a power loss occur, the mounting could
come loose.
When mounting the tool to a vertical surface, the
safety chain must be used to secure the tool to the
surface.
1. To mount the tool to a vertical surface, place the
magnetic drill press on the prepared surface. Push
the magnet button on to activate the magnet.
2. Route the safety chain through the lower carry-
ing handle and wrap it tightly around a solid, rigid
structure as shown.
3. Eliminate any slack in the chain. Hook the safety
chain together using the snaphook provided.
4. Secure the safety chain with a c-clamp or similar
device. This will hold the chain in place and prevent
the tool from sliding down the vertical surface.
To reduce the risk of injury, wear
WARNING
safety goggles or glasses with side
shields. Unplug the tool before changing acces-
sories or making adjustments.

Control Panel

A
D, E
A - Drill Rotation Speed - Fast/Slow
Adjusting the dial changes the drill rotation speed
electronically. The higher numbers on the dial pro-
duce faster rotation.
B - Forward Drill Button
C - Reverse Drill Button
The drill may be set to two positions: forward and
reverse.
1. For forward (clockwise) rotation, push the green
forward button. Check the direction of rotation
before use.
2. For reverse (counterclockwise) rotation, push the
yellow reverse button. Check direction of rotation
before use.
D - Magnet Button - On/Off
The magnet button must be activated before the
drill will run.
1. To turn the magnet on, push the "Magnet" button.
The red indicator light will turn on.
2. To turn the magnet off, push the "Magnet" button.
The red indicator light will turn off.
E - Drill and Magnet Interlock
The drill will not operate unless the magnet button is
pushed and the red indicator light is on. If the opera-
C-clamp
tor attempts to start the drill before turning on the
magnet, the drill buttons will not function.
To start the drill:
1. Push the magnet button to activate the magnet.
2. Make sure the red indicator light is on. If the light
is flashing, check for the following:
• Low voltage at plug
• Loose motor connection
• Mag panel buttons are jammed or stuck
If flashing light still occurs, take entire unit to an
authorized service center.
3. Push a drill button for forward or reverse.
If a loss of line voltage occurs while the drill is
running, the drill will stop.
Cat. Nos. 4292-1 and 4297-1 operate in either high
B
or low speed. Use low speed for large diameter bits
and high speed for small diameter bits (see "Speci-
fications" chart).
To change speeds, turn the drill off and rotate the
lever up or down while the drill is coasting to a stop.
NOTE: To avoid damage to the gearbox, do not shift
at full speed, when the tool is under load, or when
the tool has stopped.
The gear shift on the motor is labeled:
C
L - for low speed
H - for high speed
6

Gear Shift Lever