BERTO'S 700 Série Mode D'emploi page 81

Replacing the lights
- Disconnect the power supply cables.
- Remove the lamp.
- Assemble the new lamp by following the sequence in
reverse.
Replacing the operating thermostat or the safety
thermostat
- After removing the front panel, disconnect the power
supply cables.
- Remove the bulb, located at the tank bottom, from the
front side.
- Remove the thermostat by unscrewing the support
WARRANTY CERTIFICATE
COMPANY NAME:
____________________________________________________________________________________________
ADDRESS:
____________________________________________________________________________________________________
POSTAL CODE:
___________
PROVINCE:
_______________
ATTENTION!
The manufacturer declines all responsibility for any inaccuracies in this handbook due to typing or printing errors.
The manufacturer reserves the right to make any changes that may be required without altering the basic features of the
product.
The manufacturer declines all responsibility in the event that the instructions given in this handbook are not fully
observed.
The manufacturer declines all responsibility for any direct or indirect damaged caused by incorrect installation, tampering,
poor maintenance and negligent use.
TOWN:
___________________________________________________________________________
INSTALLATION DATE:
____________________________________________________________
MODEL.
_________________________________________
PART NUMBER:
________________________________
fixing screws.
- Assemble the new thermostat by following the
sequence in reverse.
Replacing the switch
- After removing the front panel, disconnect the power
supply cables.
- Replace the switch, unscrewing the support fixing
screws; the operating coaxial thermostat should have
been removed.
- Assemble the new switch by following the sequence in
reverse.
| 77
EN