Bosch PPW3320 Mode D'emploi page 10

en
Analysis function
Important: Pregnant women and persons
with implanted medical devices such as
pacemakers may only use the weighing
function.
To measure the percentage of body
fat / body water and to calculate your BMI,
first input your personal data.
The scales have 10 memory locations in
which personal data such as height, age
and sex is input.
Note: If no button is pressed within 15 sec.
during programming, the scales automati-
cally switch off.
If the Navigation buttons ▼▲ are held
down for longer, the numerical sequence is
accelerated.
Inputting personal data
Fig. D
■ Switch on the scales and wait until
indicated.
■ Press the SET button. The setting for the
personal memory location flashes.
■ Use the Navigation buttons ▼▲ to select
a personal memory location from 1-10.
■ Confirm by pressing the SET button.
C
The symbol for
flashes.
■ Use the Navigation buttons ▼▲ to select
your sex.
■ Confirm by pressing the SET button.
The setting for inputting your age now
flashes.
■ Use the Navigation buttons ▼▲ to select
your age.
■ Press the SET button. The setting for
inputting your height now flashes.
■ Use the Navigation buttons ▼▲ to select
your height.
■ Confirm by pressing the SET button.
All settings are now displayed for approx.
2 seconds each, and
display. The scales automatically switch off
after a couple of seconds. To assign other
memory locations, repeat the process for
inputting personal data.
8
D
(female) or (male) now
is indicated on the
0. 0
Note: Memory locations that are already
occupied can be reprogrammed at any
time.
Starting analysis
Measuring weight as well as BMI, and the
percentage of body fat / body water.
Fig. E
■ Switch on the scales and wait until
indicated.
■ With the USER button select the
programmed personal memory location,
e.g. 2. The personal data input is
displayed for 2 seconds each.
■ As soon as the scales display
on the scales and stand still for as long as
the display flickers. Distribute your weight
evenly on both legs.
Note: Only stand on the scales with bare
feet. Initial display for approx. 3 seconds
– Weight in kg
is
0. 0
The analysis function now takes a few
seconds to perform measurement and
calculation. Successive displays of data
– Weight in kg
– Body Mass Index BMI
– Body fat percentage FAT in %
– Body water percentage
for approx. 3 seconds each.
These displays are automatically repeated
twice in succession.
Important: Stand with your feet, calves
and thighs apart or the measurement will
otherwise be incorrect.
The scales automatically switch off a couple
of seconds after the end of the measuring
process.
The measuring results shown on the scales
are all individual values and should not be
added together. Otherwise the total will
exceed 100%.
is
0. 0
, step
0. 0
M
in %