Satelec Acteon P5 Newtron Manuel D'utilisation page 6

- When the device is not to be used for a long
period of time, rinse thoroughly, then unplug
the device from the electric supply.
- Do not attempt to move the device during use.
Environment:
- Do not cover the device or obstruct the
ventilation vents.
- Do not immerse the device in liquid, and do not
use it outdoors.
- Do not tilt the device at an angle greater than
5°.
- Do not place the device near a heat source.
- Make sure that the cords are not in the traffic
path.
- The device should be stored in its original
packaging in a safe place.
- The device is not designed for use in the
presence of anesthetic gases or any other
flammable gas.
- Do not expose the device to water vapor, or
splashes.
- Any condensation inside an electrical device is a
potential hazard.
- If the device needs to be taken from a cold area
to a hot area, allow it to reach room
temperature before use.
- The device is not designed to work near ionizing
radiation.
- Do not insert metal objects into the device (risk
of electric shock, short-circuit or emission of
hazardous substances).
6
Maintenance:
- The device must be rinsed with water supply
before and after each use.
Accessories:
- The device has been designed and developed
with its accessories to meet maximum
standards of safety and performance
- The use of any other manufacturer's accessories
presents a potential hazard for the practitioner,
the patient and the device.
Repair:
- Do not repair or modify the device without prior
authorization from SATELEC.
- In the case of a fault, contact the supplier of
your device. Do not use unauthorized repairers,
who might make your device dangerous for you
and your patients.
If you have any doubt, contact an approved
dealer or the SATELEC customer support
department:
- www.acteongroup.com
- E-mail: satelec@acteongroup.com.