Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
Use the steadying tool provided, insert pins
V2
nut
in the blade rotation direction and remove the flange and blade.
S/A Blades replacement tool (Z18303 provided)
Allen key 10
Allen key 6
8.A.c Refiting the blades
Type of blade recommended : (See page 39)
Do not use steel blades (HS type)
Clean blades and flanges. Install the blade (teeth in cutting direction). Check the rotation direction indicated on the support.
Refit the flange and screw, tightening it while immobilising the shaft with the steadying handle.
Refit the blade protection case and tighten the three captive screws V1-V2 and V3.
Figure 8-4
G
in the blade flange to immobilise the shaft, tighten the screw
V2
Figure 8-5
G
V1-V2-V3
Remove the blade protection case after
unscrewing the three captive screws
V2
V3
and
.
V1
V1
CS969
V
-
1
then, loosen the
36
Publicité
Table des Matières
