Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
USER MANUAL
SAWING
During all settings operations the blades must be switched off.
All settings must be done cover closed. This do not require any intervention inside the machine.
This is intended to ensure the safety of the operator who should never put his hands inside the cover
7.C.a Setting the vertical and horizontal clamps
-
Check that the cover is locked and the green light V1 is on. If this is not the case, use button 7 (see CONTROL
PANEL page 28).
-
The horizontal clamp setting controls are on the outside of the cover, but the clamps themselves are inside. They
can be seen through the window on the cover.
-
Place the moulding on the working table, from the left of the machine with the rebate side facing the saw blades
and position the vertical and horizontal clamps according to the profile and width of the moulding using handles
B & B', C & C'. In order to guarantee a high-quality cut, and the essential safety conditions, check that the
moulding is not in an unstable position after applying the vertical and horizontal clamps.
-
To check this position, retract the horizontal clamps and move the vertical clamps using button 6 (see
CONTROL PANEL page 28); check that the moulding does not tilt and that its underside is flat against
the table. If a satisfactory position of the vertical clamps on the moulding cannot be found, they must
be cancelled by setting them to the "0" mark of the graduated rule. Only the horizontal clamps will
operate.
-
Bring the horizontal clamps close to the moulding (+/- 5 mm from it) and then activate them with button
6 (See CONTROL PANEL page 28); check that the back of the moulding is getting pressed by the stops
(W & W') (Figure 7-4, Page 30). If this is not the case, fully retract the horizontal clamps (Figure 7-4,
Page 30).
Note: it is essential to have at least one of the two kinds of clamp activated. If this is not the case, it is
strictly forbidden to proceed to cut of the moulding
B'
B
C'
C
Moulding guide
Figure 7-3
CS969
29
Publicité
Table des Matières
