Introduction; Residual Risks; Warranty - Cassese CS969 Manuel D'utilisation

USER MANUAL

4 / INTRODUCTION

Saw CS 969 is a machine used to cut 45° mitres on all mouldings with solid or reconstituted wood base, and with or without coating
(paint, varnish, plastic coating, paper, metal leaf such as gold, bronze, aluminium, etc.).
It cannot be used for:
-
Moulding profiles that do not have a 90° heel greater than 5 mm in height,
-
Any metal profiles,
-
Thin extruded plastic profiles: (plastic cords, trimmings, etc.)
Its two circular blades are driven by two electric motors.
The moulding is held automatically by vertical and horizontal pneumatic cylinders.
A two-hand control, actuating both clamping and cutting, ensures operator safety by keeping hands out of range of the blades.
The electrical control equipment is placed in a cabinet in front of the machine.
The pneumatic equipment is secured in the base of the machine behind the electrical cabinet.
This machine was built to meet safety and hygiene requirements. It is therefore forbidden to modify the electrical and pneumatic
equipment, remove protective equipment installed on delivery or modify the machine safety devices.
Saw CS 969 cannot be used by more than one operator at a time.

RESIDUAL RISKS

Hands must never be inserted inside the beyond the plastic screens of the top protection cover as this section contains the pressure
cylinders and rotating saw blades in their high idle position.

WARRANTY

This machine is covered by a one-year warranty, parts and labor included. Wearing parts and damaged parts due to bad use of the
machine are not covered by the warranty.
CS969
15